Aksu Z, Balibek E
Hacettepe University, Department of Chemical Engineering, 06532 Beytepe, Ankara, Turkey.
J Hazard Mater. 2007 Jun 25;145(1-2):210-20. doi: 10.1016/j.jhazmat.2006.11.011. Epub 2006 Nov 15.
Some industrial wastewaters contain high quantities of salts besides heavy metal ions. The presence of salt ions leads to high ionic strength, which may significantly affect the performance of the biosorption process so the effect of salts on the biosorption of heavy metal ions should be investigated. In this study the biosorption of chromium(VI) from saline solutions on dried Rhizopus arrhizus was studied as a function of pH, initial chromium(VI) and salt (NaCl) concentrations in a batch system. The biosorption capacity of R. arrhizus strongly depended on solution pH and maximum chromium(VI) sorption capacity of sorbent was obtained at pH 2.0 both in the absence and in the presence of increasing concentrations of salt. Chromium(VI)-salt biosorption studies were performed at this pH value. Equilibrium uptakes of chromium(VI) increased with increasing chromium(VI) concentration up to 250mgl(-1) and decreased considerably by the presence of increasing concentrations of salt. At 100mgl(-1), initial chromium(VI) concentration, dried R. arrhizus biosorbed 78.0mgg(-1) of chromium(VI) in 72h without salt medium. When salt concentration was raised to 50gl(-1), this value dropped to 64.0mgg(-1) of chromium(VI) at the same conditions resulting in 17.9% decrease of biosorption capacity. The equilibrium sorption data were analysed by using Freundlich, Langmuir, Redlich-Peterson and Langmuir-Freundlich (Sips), the two and three parameters adsorption models, using non-linear regression technique and isotherm constants were evaluated depending on salt concentration. The Langmuir-Freundlich (Sips) was the best suitable adsorption model for describing the biosorption of chromium(VI) individually and in salt-containing medium. Pseudo-first-order, pseudo-second-order and saturation type kinetic models described the biosorption kinetics accurately at all chromium(VI) concentrations in the absence and in the presence of changing concentrations of salt. Isotherm and saturation type kinetic constants varied due to the level of salt were expressed as a function of initial salt concentration.
一些工业废水除了含有重金属离子外,还含有大量盐分。盐离子的存在导致离子强度较高,这可能会显著影响生物吸附过程的性能,因此应研究盐对重金属离子生物吸附的影响。在本研究中,在间歇系统中,研究了干燥的少根根霉对盐溶液中铬(VI)的生物吸附,该吸附过程是pH值、初始铬(VI)和盐(氯化钠)浓度的函数。少根根霉的生物吸附能力强烈依赖于溶液pH值,且在不存在盐以及盐浓度增加的情况下,吸附剂在pH 2.0时均获得最大铬(VI)吸附容量。在该pH值下进行了铬(VI)-盐生物吸附研究。铬(VI)的平衡吸附量随着铬(VI)浓度增加至250mg/L而增加,而随着盐浓度增加而显著降低。在初始铬(VI)浓度为100mg/L时,在无盐介质中,干燥的少根根霉在72小时内生物吸附了78.0mg/g的铬(VI)。当盐浓度提高到50g/L时,在相同条件下该值降至64.0mg/g的铬(VI),导致生物吸附容量下降17.9%。采用Freundlich、Langmuir、Redlich-Peterson和Langmuir-Freundlich(Sips)两种和三种参数的吸附模型,利用非线性回归技术分析平衡吸附数据,并根据盐浓度评估等温线常数。Langmuir-Freundlich(Sips)是描述铬(VI)在单独情况下以及在含盐介质中的生物吸附的最合适吸附模型。拟一级、拟二级和饱和型动力学模型准确描述了在不存在盐以及盐浓度变化时所有铬(VI)浓度下的生物吸附动力学。由于盐水平导致的等温线和饱和型动力学常数变化表示为初始盐浓度的函数。