Suppr超能文献

使用激光诱导石墨烯涂层无纺空气过滤器进行低压细菌和病毒杀灭。

Low-Voltage Bacterial and Viral Killing Using Laser-Induced Graphene-Coated Non-woven Air Filters.

机构信息

Dept. of Desalination and Water Treatment, Zuckerberg Institute of Water Research, The Jacob Blaustein Institutes for Desert Research, Ben-Gurion University of the Negev, Midreshet Ben Gurion 8499000, Israel.

出版信息

ACS Appl Mater Interfaces. 2021 Dec 15;13(49):59373-59380. doi: 10.1021/acsami.1c20198. Epub 2021 Dec 1.

Abstract

Laser-induced graphene (LIG) is uniquely positioned to advance applications in which electrically conductive carbon coatings are required. Recently, the antifouling, antiviral, and antibacterial properties of LIG have been proven in both air and water filtration applications. For example, an unsupported LIG based filter (pore size: ∼0.3 μm) demonstrated exceptional air filtration properties, while its joule heating effects successfully sterilized and removed unwanted biological components in air despite persisting challenges such as pressure drop, energy consumption, and lack of mechanical robustness. Here, we developed a polyimide (PI) non-woven supported LIG air filter with negligible pressure drop changes compared to the non-woven support material and showed that low electrical current density inactivates aerosolized bacteria. A current density of 4.5 mA/cm did not cause significant joule heating, and 97.2% bacterial removal was obtained. The low-voltage antibacterial mechanism was elucidated using bacterial inhibition experiments on a titanium surface and on an LIG surface fabricated on dense PI films. Complete sterilization was obtained using current densities of ∼8 mA/cm applied for 2 min or ∼ 6 mA/cm for 10 min upon the dense PI-LIG surface. Lastly, >98% bacterial removal was observed using a low-resistance LIG-coated non-woven polyimide air filter at 5 V. However, only very low voltages (∼0.3 V) were needed to remove ∼99% bacteria and 100% of T4 virus when the LIG-coated filters were hybridized with a stainless steel mesh. Our results show that low current density levels at very low voltages are sufficient for substantial bacterial and viral inactivation, and that these principles might be effectively used in a wide number of air filtration applications such as air conditioners or other ventilation systems, which might limit the spread of infectious particles in hospitals, homes, workplaces, and the transportation industry.

摘要

激光诱导石墨烯(LIG)在需要导电碳涂层的应用中具有独特的优势。最近,LIG 的抗污、抗病毒和抗菌性能已在空气和水过滤应用中得到证实。例如,一种无支撑的基于 LIG 的过滤器(孔径:∼0.3 μm)表现出出色的空气过滤性能,而其焦耳加热效应成功地对空气中的不需要的生物成分进行了消毒和去除,尽管存在压力降、能量消耗和缺乏机械强度等持续存在的挑战。在这里,我们开发了一种聚酰亚胺(PI)无纺支撑的 LIG 空气过滤器,与无纺支撑材料相比,其压降变化可忽略不计,并表明低电流密度可以使气溶胶细菌失活。电流密度为 4.5 mA/cm 时不会引起明显的焦耳加热,并且可以获得 97.2%的细菌去除率。在钛表面和致密 PI 薄膜上制造的 LIG 表面上进行细菌抑制实验,阐明了低电压抗菌机制。在致密 PI-LIG 表面上施加约 8 mA/cm 的电流密度持续 2 分钟或施加约 6 mA/cm 的电流密度持续 10 分钟即可实现完全灭菌。最后,在 5 V 下,使用低电阻 LIG 涂层无纺聚酰亚胺空气过滤器可观察到>98%的细菌去除率。然而,当 LIG 涂层过滤器与不锈钢网杂交时,只需要非常低的电压(约 0.3 V)即可去除约 99%的细菌和 100%的 T4 病毒。我们的结果表明,非常低的电压下的低电流密度足以实现实质性的细菌和病毒失活,并且这些原理可能会在许多空气过滤应用中得到有效利用,例如空调或其他通风系统,这可能会限制传染病颗粒在医院、家庭、工作场所和运输业中的传播。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验