Jung Jae-Won, Kim Siyoung, Kim Yong-Soon, Jeong Sanghyun, Lee Jieun
Water quality research institute, Busan Water Authority, Busan 47210, South Korea.
Department of Environmental Engineering, Pusan National University, Busan 46241, South Korea.
Sci Total Environ. 2022 Jun 15;825:154015. doi: 10.1016/j.scitotenv.2022.154015. Epub 2022 Feb 19.
The increasing amount of plastic waste has raised concerns about microplastics (MPs) in aquatic environments. MPs can be fragmented into nanoplastics that can pass through water treatment processes and into tap water; potentially threatening human health because of their high adsorption capacity for hazardous organic materials and their intrinsic toxicity. This case study investigates the identification, fate, and removal efficiency of MPs in Korean drinking water treatment plants. Two sites on the Nakdong River, two lake reservoirs (raw water sources), and four corresponding drinking water treatment plants were targeted to trace the amounts, types, and sizes of MPs throughout the treatment process. Monthly quantitative and qualitative analyses were conducted by chemical image mapping using micro-Fourier-transform infrared spectroscopy. MPs larger than 20 μm were detected, and their sizes and types were quantified using siMPle software. Overall, the number of MPs in the river sites (January to April and October to November) exceeded those in the reservoirs, but only slight differences in the number of MPs between rivers and lake reservoirs were detected from June to October. The annual average number of MPs in River A, B and Lack C and D was not distinctively different (2.65, 2.48, 2.46 and 1.87 particles/L, respectively). The majority of MPs found in raw waters were polyethylene (PE)/polypropylene (PP) (> 60%) and polyethylene terephthalate (PET)/poly(methyl methacrylate) (PMMA) (20%), in addition to polyamide (<10%) in the river and polystyrene (<10%) in the lake reservoirs. Approximately 70-80% of the MPs were removed by pre-ozonation/sedimentation; 81-88% of PE/PP was removed by this process. PET/PMMA was removed by filtration. Correlation of MPs with water quality parameters showed that the Mn concentration was moderately correlated with the MP abundance in rivers and lake reservoirs, excluding the lake with the lowest Mn concentration, while the total organic carbon was negatively correlated with the MP abundance in both rivers (A and B) and lake reservoir C.
塑料垃圾数量的不断增加引发了人们对水生环境中微塑料(MPs)的担忧。微塑料可破碎成纳米塑料,这些纳米塑料能够通过水处理过程进入自来水;由于其对有害有机物质的高吸附能力及其内在毒性,可能会威胁人类健康。本案例研究调查了韩国饮用水处理厂中微塑料的识别、去向和去除效率。以洛东江的两个地点、两个湖泊水库(原水源)以及四个相应的饮用水处理厂为目标,以追踪整个处理过程中微塑料的数量、类型和尺寸。每月使用微傅里叶变换红外光谱通过化学图像映射进行定量和定性分析。检测到大于20μm的微塑料,并使用siMPle软件对其尺寸和类型进行量化。总体而言,河流站点(1月至4月和10月至11月)的微塑料数量超过了水库中的数量,但6月至10月期间,河流和湖泊水库之间的微塑料数量仅存在细微差异。A河、B河以及C湖和D湖的微塑料年均数量没有显著差异(分别为2.65、2.48、2.46和1.87颗粒/升)。原水中发现的大多数微塑料是聚乙烯(PE)/聚丙烯(PP)(>60%)和聚对苯二甲酸乙二酯(PET)/聚甲基丙烯酸甲酯(PMMA)(20%),此外河流中的聚酰胺(<10%)和湖泊水库中的聚苯乙烯(<10%)。大约70 - 80%的微塑料通过预臭氧化/沉淀去除;此过程去除了81 - 88%的PE/PP。PET/PMMA通过过滤去除。微塑料与水质参数的相关性表明,除了锰浓度最低的湖泊外,河流和湖泊水库中的锰浓度与微塑料丰度呈中度相关关系,而河流(A和B)以及湖泊水库C中的总有机碳与微塑料丰度呈负相关关系。