Queensland Alliance of Environmental Health Sciences, The University of Queensland, 20 Cornwall Street, Woolloongabba, Queensland 4102, Australia.
Queensland Alliance of Environmental Health Sciences, The University of Queensland, 20 Cornwall Street, Woolloongabba, Queensland 4102, Australia.
Sci Total Environ. 2020 Dec 10;747:141175. doi: 10.1016/j.scitotenv.2020.141175. Epub 2020 Jul 25.
An emission source of microplastics into the environment is laundering synthetic textiles and clothing. Mechanical drying as a pathway for emitting microplastics, however, is poorly understood. In this study, emissions of microplastic fibres were sampled from a domestic vented dryer to assess whether mechanical drying of synthetic textiles releases microplastic fibres into the surrounding air or are captured by the inbuilt filtration system. A blue polyester fleece blanket was repeatedly washed and dried using the 'Normal Dry' program of a common domestic dryer operated at temperatures between 56 and 59 °C for 20 min. Microfibres in the ambient air and during operation of the dryer were sampled and analysed using microscopy for particle quantification and characterisation followed by Fourier-Transform Infrared Spectroscopy (FTIR) and Pyrolysis Gas Chromatography-Mass Spectrometry (Pyr-GC/MS) for chemical characterisation. Blue fibres averaged 6.4 ± 9.2 fibres in the room blank (0.17 ± 0.27 fibres/m), 8.8 ± 8.5 fibres (0.05 ± 0.05 fibres/m) in the procedural blank and 58 ± 60 (1.6 ± 1.8 fibres/m) in the sample. This is the first study to measure airborne emissions of microplastic fibres from mechanical drying, confirming that it is an emission source of microplastic fibres into air - particularly indoor air.
衣物洗涤和机械干燥是微塑料向环境释放的来源之一。然而,机械干燥作为微塑料排放的途径,其机制仍不清楚。在这项研究中,从家用通风式干衣机中采集微塑料纤维排放物,以评估合成纤维纺织品的机械干燥是否会将微塑料纤维释放到周围空气中,或者是否被内置过滤系统捕获。使用普通家用干衣机的“正常干燥”程序,将蓝色聚酯绒面毯子反复洗涤和干燥,温度在 56 至 59°C 之间,持续 20 分钟。使用显微镜对环境空气中和干燥机运行过程中的微纤维进行采样和分析,进行颗粒定量和特征分析,然后使用傅里叶变换红外光谱(FTIR)和热解气相色谱-质谱(Pyr-GC/MS)进行化学特征分析。在房间空白处,蓝色纤维平均为 6.4±9.2 根(0.17±0.27 根/米),在程序空白处为 8.8±8.5 根(0.05±0.05 根/米),在样本中为 58±60 根(1.6±1.8 根/米)。这是第一项测量机械干燥过程中空气传播的微塑料纤维排放的研究,证实了它是微塑料纤维向空气排放的来源之一——特别是室内空气。